9. USAGE EXAMPLE
IMR02E20-E1
74
9.3 Use Instruments Settings
COM-ML setting
There is not the setting of the hardware.
In this example the initial settings for COM-ML communication data are configured using
loader communication, and thus COM-ML host communication settings are not necessary.
Controller (SRZ) setting
The COM-ML and controllers (Z-TIO modules) are connected by internal communication, and
settings for the Z-TIO modules such as communication speed, protocol, and data bit configuration are
not necessary.
The only setting that is configured for the controllers is the module address. The same is true when a
Z-DIO module and a Z-CT module are used.
Module address: Z-TIO module: 1
For the procedure for module address settings, refer to
Z-TIO Host Communication
Quick Instruction Manual (IMS01T02-E
)
,
Z-DIO INSTRUCTION MANUAL
(IMS01T03-E
)
and
Z-CT INSTRUCTION MANUAL (IMS01T16-E
).
PLC setting
There is not the setting of the hardware. Use engineering software to configure PROFINET settings.
For details,
9.5 Tool Settings (P. 76)
.
