8. COMMUNICATION DATA LIST
IMR02E20-E1
35
The Engineering setting data should be set according to the application before setting
any parameter related to operation. Once the communication data in the Engineering
mode are set correctly, no further changes need to be made to parameters for the
same application under normal conditions. If they are changed unnecessarily, it may
result in malfunction or failure of the instrument. RKC will not bear any responsibility for
malfunction or failure as a result of improper changes in the Engineering mode.
Some of the communication data of the COM-ML will not be enabled until the power is
turned on again, or control is switched from STOP to RUN.
Communication data No. 22 to 25, 27, 33 to 36, 42
Communication data includes both “Normal setting data” and “Engineering setting
data.” During RUN (control), the attribute of Engineering setting data is RO. To
configure Engineering setting data, the RUN/STOP switch must be set to STOP
(control stopped).
Z-TIO module: Normal setting data No. 1 to 85
Engineering setting data No. 86 to 208
Z-DIO module: Normal setting data No. 1 to 13
Engineering setting data No. 14 to 27
Z-CT module: Normal setting data No. 1 to 16
Engineering setting data No. 17 to 28 *
* No. 17 to 28: When the set lock (Identifier: LK, Resister address: 5E0CH to 5E1BH)
is set to “0: Unlock,” writing data is possible.
