6
IMR02E20-E1
2. HANDLING PROCEDURES
Conduct necessary setting before operation according to the procedure described below.
Mounting
Install the COM-ML.
Refer to
3. MOUNTING (P. 7)
.
For controller (SRZ), refer to
Z-TIO Instruction Manual
(IMS01T01-E
),
Z-DIO Instruction Manual (IMS01T03-E
)
and
Z-CT Instruction Manual (IMS01T16-E
)
.
Host communication
settings
Wiring
Controller (SRZ) settings
PROFINET
communication settings
The address, communication speed, communication protocol, data bit
configuration, and DIP switch setting validity/invalidity of host
communication are set only when host communication is used in the
COM-ML.
Refer to
5. HOST COMMUNICATION SETTINGS (P. 21)
.
Connect power wiring to the COM-ML, make wiring to the controller
(SRZ), and connect the COM-ML and the PLC to PROFINET. Connect
the wiring for host communication or loader communication in the
COM-ML.
Refer to
4. WIRING (P. 12)
For controller (SRZ), refer to
Z-TIO Instruction Manual
(IMS01T01-E
),
Z-DIO Instruction Manual (IMS01T03-E
)
and
Z-CT Instruction Manual (IMS01T16-E
)
.
Set the communication setting of controller (SRZ).
Refer to
6. COMMUNICATIOM SETTING OF
FUNCTION MODULE (P. 23)
.
For controller (SRZ), refer to
Z-TIO Host Communication
Quick Instruction Manual (IMS01T02-E
),
Z-DIO
Instruction Manual (IMS01T03-E
)
and
Z-CT Instruction
Manual (IMS01T16-E
)
.
Configure initial settings for PROFINET communication.
Refer to
7.1 PROFINET Communication Settings (P. 27)
.
Refer to
7.4 PROFINET Communication Specifications
(P. 32)
.
Refer to
9.5 Tool Settings (P. 76)
.
Other communication
data settings
Set the data for the COM-ML and controller (SRZ).
Refer to
7.2 Other Communication Data Settings (P. 31)
.
Refer to
8. COMMUNICATION DATA LIST (P. 34)
.
PROFINET
communication
Execute PROFINET communication.
Refer to
7.1 PROFINET Communication Settings (P. 27)
.
Refer to
7.4 PROFINET Communication Specifications
(P. 32)
.
Refer to
9.5 Tool Settings (P. 76)
.
Refer to
9.6 PROFINET Communication (P. 92)
.
