Ricoh LD430c, Operating Instructions Manual, Page: 241 / 964

Special Senders to Treat Differently
163
4
❒
Deleting a destination specified as a forward destination from the destina-
tion list causes the settings of the forward destination to be deleted, so they
must be registered again. When a destination is changed, a document is
transmitted to the new destination. If there is no destination of the speci-
fied type, you can set which destination to be used as an alternative desti-
nation. See “Parameter Settings” (switch 32, bit 0).
❒
After you perform step
J
, set “Forwarding” of “Reception Settings” to
“On”.
Reference
p.149 “Parameter Settings”
p.235 “Registering Folders”
Print 2 Sided
Specify when programming a Special Sender.
A
Press [ 2 Sided Print per Sender ] .
B
Press [ On ] or [ Off ] , and then press [ OK ] .
Note
❒
Selecting
[ Same as Basic Settings ]
will result in the same setting made for “2
Sided Print” of “Reception Settings”.
Memory Lock
Specify when programming a Special Sender.
A
Press [ Memory Lock Reception per Sender ] .
B
Press [ On ] or [ Off ] , and then press [ OK ] .
Note
❒
Selecting
[ Same as Basic Settings ]
will result in the same setting made for
“Program Memory Lock ID” under “Administrator Tools”.
Paper Tray
Specify when programming a Special Sender.
A
Press [ Paper Tray per Sender ] .
B
Select the tray you want to use, and then press
[ OK ]
.
Note
❒
Selecting
[ Same as Basic Settings ]
will result in the same setting made for
“Paper Tray” of “Reception Settings”.