Ricoh LD430c, Operating Instructions Manual, Page: 217 / 964

Program / Change / Delete Scan Size
139
4
Program / Change / Delete Scan Size
Program frequently used scan sizes.
Important
❒
When programming or changing a scan size, it is recommended that you
make a record of the new size.
When you select a scan size to scan a custom size original, two custom sizes are
available (Program Size 1 and Program Size 2). Use these functions to program
a custom size in advance. The procedure is the same for programming and
changing.
You can program up to two sizes.
Specify a horizontal length from 128 to 1200 mm, or from 5.5 to 47 inches.
A
Press [ Facsimile Features ] .
B
Press [ Scan Settings ] .
C
Press [ Program / Change / Delete Scan Size ] .
D
Select [ Program Size 1 ] or [ Program Size 2 ] .
E
Enter a horizontal size using the number keys.
Each time you press [ mm ] or [ inch ] , the units switch between “mm” and
“inch”. If you enter a length and press [ mm ] or [ inch ] , the length is converted
automatically according to the unit (fractions are rounded off). For example,
when you enter
{
2
}
,
{
2
}
, and
{
0
}
in millimeters and change to “inch”, the
length “8.7 inch” is shown on the display. If you press [ mm ] or [ inch ] again,
“221 mm” is displayed.
If you make a mistake, press
[ Clear ] or the
{
Clear/Stop
}
key, and then try again.
To cancel a scan size, press [ Cancel ] .