Raritan PX3TS, User Manual

Page: 551 / 842

Chapter 8: Using the Command Line Interface
527
Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier
(SSID), authentication method, Pre-Shared Key (PSK), and Basic Service
Set Identifier (BSSID) after the wireless networking mode is enabled.
A wireless configuration command begins with network wireless.
Note: If current networking mode is not wireless, the SSID, PSK and
BSSID values are not applied until the networking mode is changed to
"wireless." In addition, a message appears, indicating that the active
network interface is not wireless.
Setting the SSID
This command specifies the SSID string.
config:# network wireless SSID <ssid>
Variables:

<ssid> is the name of the wireless access point, which consists of:
- Up to 32 ASCII characters
- No spaces
- ASCII codes 0x20 ~ 0x7E
Setting the Authentication Method
This command sets the wireless authentication method to either PSK or
Extensible Authentication Protocol (EAP).
config:# network wireless authMethod <method>
Variables:

<method> is one of the authentication methods:
PSK or EAP.
Method Description
PSK The wireless authentication method is set to PSK.
EAP The wireless authentication method is set to EAP.