Chapter 8: Using the Command Line Interface
522
config:#
network ipv6 staticRoutes add <dest-1> interface <ETH>
Delete an existing static route:
config:#
network ipv6 staticRoutes delete <route_ID>
Modify an existing static route:
config:#
network ipv6 staticRoutes modify <route_ID> <dest-2> <hop>
-- OR --
config:#
network ipv6 staticRoutes modify <route_ID> <dest-2> interface <ETH>
Variables:
<dest-1> is the IP address and prefix length of the subnet where the
PX3TS belongs. The format is
IP address/prefix length.
<hop> is the IP address of the next hop router.
<ETH> is one of the interfaces:
ethernet, wireless and bridge. Type
"bridge" only when your PX3TS is in the bridging mode.
<route_ID> is the ID number of the route setting which you want to
delete or modify.
<dest-2> is a modified route setting that will replace the original
route setting. Its format is
IP address/prefix length. You can modify
either the IP address or the prefix length or both.
Summary of Contents for PX3TS
