Raritan PX3TS, User Manual

Page: 497 / 842

Chapter 8: Using the Command Line Interface
473
Interface Description
eth2
(PX3TS-iX7)
Show the IPv4 or IPv6 configuration of the ETH2
interface.
wireless Show the IPv4 or IPv6 configuration of the
WIRELESS interface.
bridge Show the IPv4 or IPv6 configuration of the BRIDGE
interface.
all Show the IPv4 or IPv6 configuration of all
interfaces.
Tip: You can also type the command without
adding this option "all" to get the same data. That
is, show network ipv4 interface.
Network Interface Settings
This command shows the specified network interface's information
which is NOT related to IP configuration. For example, the Ethernet
port's LAN interface speed and duplex mode, or the wireless interface's
SSID parameter and authentication protocol.
# show network interface <ETH>
Variables:

<ETH> is one of the network interfaces:
ethernet, wireless, or bridge.
Note that you must choose/configure the bridge interface if your
PX3TS is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET and
WIRELESS interfaces do NOT function.
Interface Description
ethernet
(PX3TS) Show the ETHERNET interface's non-IP settings.
eth1
(PX3TS-iX7)
Show the ETH1 interface's non-IP settings.
eth2
(PX3TS-iX7)
Show the ETH2 interface's non-IP settings.