Raritan PX3TS, User Manual

Page: 426 / 842

Chapter 6: Using the Web Interface
402
Miscellaneous
By default, the Schroff LHX/SHX heat exchanger support and Cisco
EnergyWise feature implemented on the PX3TS are disabled.
Support needs to be enabled for the LHX/SHX information to appear in
the PX3TS web interface. Besides, Schroff LHX/SHX support must be
enabled in order for the LHX-MIB to be accessible through SNMP.
If a Cisco
®
EnergyWise energy management architecture is implemented
in your place, you can enable the Cisco EnergyWise endpoint
implemented on the PX3TS so that this PX3TS becomes part of the Cisco
EnergyWise domain.
To enable either feature, choose Device Settings > Miscellaneous.
To enable the support for Schroff LHX/SHX:
1. Select the Schroff LHX/SHX Support checkbox.
2. Click Save in the
Features section.
3. Click Apply on the confirmation message.
4. The PX3TS reboots.
To set the Cisco EnergyWise configuration:
1. Select the Enable EnergyWise checkbox.
2. Configure the following:
Field Description
Domain name Type the name of a Cisco EnergyWise domain where the
PX3TS belongs

Up to 127 printable ASCII characters are permitted.

Spaces and asterisks are NOT acceptable.
Domain password Type the authentication password (secret) for entering
the Cisco EnergyWise domain

Up to 127 printable ASCII characters are permitted.

Spaces and asterisks are NOT acceptable.
Port Type a User Datagram Protocol (UDP) port number for
communications in the Cisco EnergyWise domain.

Range from 1 to 65535.

Default is 43440.