Quantum Data 802BT, User Manual

Page: 75 / 744

802BT/802R Video Test Generator User Guide 65
6. Enter the following commands to load and begin editing the existing format.
FMTL format_name // loads existing format into the format editor
FMTB // begins a format editing session
7. Enter the format parameter commands in sequence where the new values differ from
the existing format values. For example to modify the horizontal resolution enter the
following command:
HRES 654
Note: You do not need to enter parameter values if they match the existing format.
8. End the editing session and save the new format using the following commands:
FMTE // ends a format editing session
FMTA new_fmt_name // saves format as new specified name
9. Assign the format to the knob list using the following commands:
DIRL FMT // loads format directory into edit buffer
DIRB // begins a directory edit session
NAMI 20 new_fmt_name // assigns format to format knob list at 20
DIRE // ends a directory editing session
DIRS // saves contents of directory as current name
Modifying existing formats
The following procedure demonstrates how to modify the parameters of an existing format
using the command interface. This example changes an existing digital format from RGB
4:4:4 to YCbCr 4:2:2, and saves the format into the default format directory.
To edit an existing format:
1. Establish a terminal session with the generator.
2. Set the generator to digital friendly mode:
SROP 2 (or SROP 2 4) // sets generator to digital friendly mode
SROP 8 // sets generator to status display mode
3. Load and begin editing the format:
FMTL existing_format // loads existing format into format editor
FMTB // begins a format editing session
4. Enter the format parameter commands in sequence where the values differ from the
default values. For example to modify the component video type enter the following
command:
DVST 14 // changes the component color to YCbCr
DVSM 2 // changes component color make up to 4:2:2
ALLU // loads hardware and outputs new signal
5. End the editing session and save the format using the following commands:
FMTE // ends the format editing session