VIBSCANNER 11.2010
5
Introduction
General safety
The following notes must be carefully read and completely
understood before VIBSCANNER is put into service.
Risk of injury when measuring on a running machine!
Observe the safety regulations. Install the measure-
ment equipment properly. During measurement on
machines with rotating parts exposed, ensure that no
brackets, cables etc. can become caught in rotating
machine parts.
- VIBSCANNER must be treated in such a way that it
is not subject to any mechanical knocks.
- VIBSCANNER may only be operated if it is undam-
aged, dry and clean.
- Operation and maintenance are to be performed
only by properly trained personnel.
- Repairs to VIBSCANNER may be carried out only by
a PRÜFTECHNIK-authorized service technician.
- Only original spare parts and accessories may be
used.
- Only properly functioning, regularly-maintained
electrical equipment may be used. Any defects such
as broken plugs or loose sockets must be corrected
immediately. Damaged cables must be replaced by
an authorized service technician.
- Any alterations that affect device design or operat-
ing safety are not permitted.
Environmental influences
- Portable radio-based devices can interfere with
proper functioning of VIBSCANNER when operated
nearby. In case of doubt, check the connecting cable
between the device and its transducer.
- Keep the protective caps on the connector sockets
when they are not in use to keep them clean.
- VIBSCANNER is only dustproof and watertight
(IP65) when the battery is plugged into the instru-
ment. Please note that, during the battery change,
the instrument and the battery only comply with
protection class IP 50 (dustproof).
WARNING!
Attention!
