VIBSCANNER 11.2010
17
Getting started
Setup menu
In the Setup menu, you can check the parameters of the
selected measurement task and change them if necessary.
The Setup menu is task-specific, i.e. the settings only
apply to the selected measurement task.
• Select the measurement task with the cursor.
• Press the function key and click on ‘Setup’:
Setup for measurement
• The parameters in the preselected setups can be
changed.
• Changes in the measurement setup can be reset to the
default settings.
Setup for transducers
Select the transducer to be used for the measurement or
create a new transducer in this submenu.
• The parameters of the preselected transducer cannot be
changed.
• Only transducers that conform to the settings of the
measurement setup and were activated in the VIBSCAN-
NER setup (see page 21) can be selected.
Example: The lower frequency limit is set to 2 Hz in the
measurement setup. For this reason, no transducers
with a linearity range that begins at 10 Hz (e.g. internal
transducers) can be selected for these tasks.
Setup for evaluation (optional)
Limiting values can be defined in this submenu to evaluate
the measurement. Optionally, the evaluation setup can be
activated.
Setup for recording (optional)
This setup forms part of the optional ‘Signal analysis’
program module (for details, see Operating Instructions
VIB 9.664.G).
Setup menu
Note
