Power Electronics SD 300 Series, Getting Started Manual

Page: 181 / 354

POWER ELECTRONICS SD300
DESCRIPTION OF PROGRAMMING PARAMETERS
179
Screen Description
Default
value
Range Function
Set on
RUN
Note
: comes from the previous page
OPT. DESC. FUNCTION
28
Timer
Out
The relay will be enabled
after the set time has
elapsed.
29 Trip
Relay is enabled when a
fault trip occurs.
31
DBWarn
%ED
Sets the configuration of
the braking resistor (%ED:
Duty cycle).
34
Compar
at Sends a signal using the
value of the digital input.
35 BRCtrl Used to control the brake
opening.
36
CAP
Exch.
The relay will enable CAP
exchange
options
according to the setting of
Pr.62.
37
FAN
Exch.
The relay will enable FAN
exchange according to the
setting of Pr.87.
38
Fire
Mode
Fire mode configuration.
39 TO
Sends pulse signals to
external devices to provide
a single output value of
output frequency, output
current, output voltage or
DC voltage.
40 KEB Op.
The relay will be active
when the energy buffering
operation has started
because of low voltage of
the drive DC power section
due to a power failure on
the input power.
OU.33
Digital output
1 function
Run 0 to 35 See parameter OU.31. YES