08
July 27, 09 K.Okada
A.Miyoshi I.Fujioka
Refer to Revision Record on page 2.
TITLE
fi-6140/fi-6240/fi-6130/fi-6230/fi-614PR
Maintenance Manual
07
Nov.12, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
CUST.
06
Mar.10, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
DRAW
No.
P1PA03540-B0XX/6
Rev. DATE DESIGN CHECK APPR. DESCRIPTION
Design
July 27, 2007
K.Okada
CHECK
K.Okada
APPR.
T.Anzai
PFU LIMITED
Page
250
/
257
Print section
Print section
Section 8-9-3
8-9-3 Cleaning the Imprinter Rollers
When ink or dust from paper is stuck on the feed roller surfaces, documents may not be fed smoothly. To prevent feed
problems, clean the roller surfaces regularly.
Recommended cleaning cycle is every 1,000 sheets. The actual cleaning cycle may be shorter depending on usage and
documents.
1. Open the Print section.
2. Clean the six rubber rollers.
The rollers are located as indicated on the right.
Wipe off any dirt or dust on the roller surface with a
lint-free cloth moistened with cleaning fluid (ethyl
alcohol).
It may take long before the cleaner vaporizes if a large quantity is used. Wipe off the cleaner completely with a soft lint-free
cloth to leave no residue on the surface of the cleaned parts.
To clean the entire surface of each roller, rotate it by holding down both the Scan/Stop and Send to buttons on the Operator
Panel of the scanner by the number of times required to make a full turn.
When cleaning, be careful not to touch the metal wheels
located behind the upper rollers on the Print section.
3. Clean the two plastic rollers (black).
The rollers are located inside the Print section as
indicated below.
Rotate the rollers with your fingers gently and wipe
off any dirt or dust from the roller surface with a
lint-free cloth moistened with cleaning fluid (ethyl
alcohol).
4. Confirm that all dirt and dust have been removed from
the rollers. Close the Print section.