08
July 27, 09 K.Okada
A.Miyoshi I.Fujioka
Refer to Revision Record on page 2.
TITLE
fi-6140/fi-6240/fi-6130/fi-6230/fi-614PR
Maintenance Manual
07
Nov.12, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
CUST.
06
Mar.10, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
DRAW
No.
P1PA03540-B0XX/6
Rev. DATE DESIGN CHECK APPR. DESCRIPTION
Design
July 27, 2007
K.Okada
CHECK
K.Okada
APPR.
T.Anzai
PFU LIMITED
Page
130
/
257
Section 5-11
5-11 Control PCA
- Refer to Section 3-23 for the part number of the replacement part.
- Refer to Appendix for the specification of the screws.
<Removal>
Remove the imprinter (option).
fi-6140/fi-6130 with Imprinter Referring to Section 8-6-4 “Removing Imprinter”, remove the Imprinter.
Remove Flatbed.
fi-6240/fi-6230 Referring to Section 5-7 “Removing Flatbed,” remove the Flatbed.
1. Remove Chuter Unit.
(1) Referring to Section 5-8-1 “Chuter Unit (ADF Paper Chute),” remove the Chuter Unit.
2. Remove Control PCA.
(2) - Place the ADF as shown below.
The photo below is fi-6240/fi-6230. fi-6140/fi-6130 does not have a connector at the bottom of the ADF.
- Remove four screws C (circles below) at the bottom of the ADF 1, tilt the Control PCA to the front 2, and then remove
the Control PCA 3.
- Disconnect eight cables of the Control PCA.
Pressing the Control PCA with fingers to prevent it from coming loose, pull out the cables straight upward.
Front side
1
2
3
Bottom of ADF
Control PCA
NG
OK
