08
July 27, 09 K.Okada
A.Miyoshi I.Fujioka
Refer to Revision Record on page 2.
TITLE
fi-6140/fi-6240/fi-6130/fi-6230/fi-614PR
Maintenance Manual
07
Nov.12, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
CUST.
06
Mar.10, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
DRAW
No.
P1PA03540-B0XX/6
Rev. DATE DESIGN CHECK APPR. DESCRIPTION
Design
July 27, 2007
K.Okada
CHECK
K.Okada
APPR.
T.Anzai
PFU LIMITED
Page
215
/
257
Section 8-6-1
8-6 Disassembly/Assembly
This chapter describes warning and cautions, how to remove or replace covers and maintenance parts for the Imprinter to ensure
the normal operations.
8-6-1 For Safety operation
Preventative maintenance is recommended on the Imprinter at the following intervals.
- Every 12 month, or at the periodic maintenance of the connected scanner
Notes at replacement work
- Clean the place where replacement work is conducted.
- Be sure to follow the described procedures. Never loosen the non-disassembly screws.
- Avoid loss of the removed parts.
- Check the quantities and shapes of the parts after replacement.
- Follow the removal procedure in reverse for the installation procedure.
Machine damage
Static Electricity changed human body due to rubbed clothes may cause the damage of electric element.
When repairing the substrate as a System Board or a Main Control Board, put a wrist strap or use a conductive mat to avoid ESD.
Injury
Be careful not to get your fingers, hair, clothes or accessories caught in a moving part. It may cause injury.
- Perform the periodic maintenance at the same time when it is performed for the image scanner.
- Refer to Section 8-9 “Daily Care” for how to clean in detail.
8-6-2 Maintenance tool
Special tools to maintain this Imprinter are shown in the table below.
No.
Tools
Remarks
When to use
1
Phillips screwdriver
M3, M4 screws
2 Small
flat-blade
screwdriver
Removing E ring, lever switch
3 Plier
Removing
clamps
4 Alcohol
Ethyl
alcohol
Cleaning
5
Spring gauge
500g
Adjusting belt tension
8-6-3 (Reserved)
