08
July 27, 09 K.Okada
A.Miyoshi I.Fujioka
Refer to Revision Record on page 2.
TITLE
fi-6140/fi-6240/fi-6130/fi-6230/fi-614PR
Maintenance Manual
07
Nov.12, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
CUST.
06
Mar.10, 08 K.Okada
T.Anzai
I.Fujioka
Refer to Revision Record on page 2.
DRAW
No.
P1PA03540-B0XX/6
Rev. DATE DESIGN CHECK APPR. DESCRIPTION
Design
July 27, 2007
K.Okada
CHECK
K.Okada
APPR.
T.Anzai
PFU LIMITED
Page
108
/
257
Section 5-10-2
5-10-2 Upper ASSY
- The Panel PCA and the OPT Unit are not included.
- A dummy TOP Cover is included.
- Remove OPT Unit from Upper Unit. The remaining assembly is Upper ASSY.
- Re-install the Panel PCA, OPT Unit, and the TOP Cover.
- Refer to Section 3-14 for the part number of the replacement part.
<Removal>
Remove the imprinter (option).
fi-6140/fi-6130 with Imprinter Referring to Section 8-6-4 “Removing Imprinter”, remove the Imprinter.
Remove Flatbed.
fi-6240/fi-6230 Referring to Section 5-7 “Removing Flatbed,” remove the Flatbed.
1. Remove Chuter Unit.
(1) Referring to Section 5-8-1 “Chuter Unit (ADF Paper Chute),” remove the Chuter Unit.
2. Remove Control PCA.
(2) Referring to step (2) of Section 5-11 “Control PCA,” remove the Control PCA.
3. Remove Upper Unit.
(3) Referring to steps (3) ~ (8) of Section 5-9-1 “Base Unit,” separate the Upper Unit and Base Unit.
4. Remove Panel PCA.
(4) Referring to Section 5-10-8 “Panel PCA,” remove the Panel PCA.
Note: There is no need to save the EEPROM data.
5. Remove Top Cover.
(5) Referring to steps (3) ~ (5) of Section 5-10-11 “Top Cover,” remove the Top Cover.
6. Remove OPT Unit.
(6) Referring to step (4) of Section 5-10-4 “OPT Unit (for backside scanning),” remove the OPT Unit.
<Installation>
Follow the above procedure in reverse.
Note: Re-install the Panel PCA, OPT Unit, and Top Cover.
Note: Do NOT pinch the cables.
Note: Upper ASSY includes Brake roller. Referring to Section 7-3-3 “Brake roller replacement,” reset the Brake roller
counter.
Note: Perform the following adjustments after replacing the parts.
- Referring to Section 6-1-3 “Maintenance Mode #2,” adjust the magnification.
- Referring to Section 6-1-4 “Maintenance Mode #3,” adjust the offset.
- Referring to Section 6-1-5 “Maintenance Mode #4,” adjust the white level.
Note: Clean the glass surface after replacing the part.
