Cypher SPM
User Guide
3. Check clip rotation.
l
Rotate the clip so it does not overhang any of the glass cutout's edges.
l
Press down on the clip so it settles down into the cutout area of the glass.
4. Tighten the screw.
l
Using a small phillips screwdriver, tighten the screw until you feel some resistance. This will
be the O-ring compressing.
l
If the clip still has a tendency to turn around during tightening of the screw, consider hold-
ing the clip pressed down (right photo) so it seats properly in the cutout feature.
9.4 Cleaning the ES cantilever holder
Only the glass parts of the cantilever holder should come into contact with fluid during cleaning. To
prevent fluid from touching the circuit components, please use the cleaning cup as shown below.
Page 59 of 243
9 Environmental scanner cantilever holders
