75
7-2-2 PC Card Slots
Slot 1
Slot 2
Slot 1: A type-I, -II, or -III PC card can be mounted in this slot.
Slot 2: A type-I or -II PC Card can be mounted in this slot. If, however, a type-III
PC Card is mounted in slot 1, slot 2 cannot be used.
Note The card inserted into slot 2 can be removed or installed by loosening the set
screws on plate 2. When removing or installing a card into slot 1, always remove
plate 2.
To avoid accidental removal of the Ethernet Card, it is recommended that the
Ethernet Card be installed in slot 1.
7-2-3 Installing and Removing an Ethernet Card
Note Use an Ethernet card that has a connector more than 3 mm away from the edge
of the card, as shown in the figure below. If the distance between the edge of the
card and the connector is 3 mm or less, the plate for securing the PC card cannot
be installed.
Ethernet card
Facing
side
3 mm
Note There is a restriction on the current consumption of the Ethernet card. Use an
Ethernet card that meets the following conditions:
I
5V
(1 slot)
≤
0.5 A, I
12V
(1 slot)
≤
0.1 A
I
5V
(2 slots) + 3.4 x I
12V
(2 slots)
≤
1.0 A
Installing and Removing the Ethernet Card
Section 7-2
Summary of Contents for SYSMAC C200HW-PCS01-EV1
