Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 116 / 261

100
7-7 Using SETUP2.EXE
SETUP2.EXE is a setup software for setting the Ethernet communications envi-
ronment, just like the setup software (SETUP.EXE) explained in 7-6 Setup Soft-
ware Operation. SETUP2.EXE is supported from the C200HW-PCS01-EV1
Ethernet Set, and it differs from SETUP.EXE in the following three ways:
•
SETUP2.EXE is run by the PC Card Unit.
•
SETUP2.EXE can read the Ethernet communications environment settings
that are set for the PC Card Unit.
•
SETUP2.EXE can delete the Ethernet communications environment settings
that are set for the PC Card Unit.
SETUP2.EXE is used with respect to PC Card Units for which the Ethernet com-
munications environment settings have been made by SETUP.EXE. It is mainly
used for reading and editing those settings for each PC Card Unit.
7-7-1 Preparation for Using SETUP2.EXE
Refer to the explanations of SETUP.EXE earlier in this section, and use
SETUP.EXE to transfer the Ethernet communications environment settings to
the PC Card Unit. When the Ethernet communications environment settings are
transferred to the PC Card Unit, SETUP2.EXE will be automatically transferred
there as well.
The following items are required in order to use SETUP2.EXE at the PC Card
Unit:
•
Personal computer
•
Host Link Cable (RS-232C)
•
Terminal software (HyperTerminal provided with Windows 95)
For details regarding instructions on personal computers and instructions on
connecting Host Link Cable, refer to 7-4 Personal Computer Setup.
7-7-2 SETUP2.EXE Procedure to Startup
The procedure up to and including SETUP2.EXE startup is outlined below.
1, 2, 3... 1. Turn OFF the power supply to the C200HX/HG/HE and the personal com-
puter.
2. Connect the personal computer to the PC Card Unit with RS-232C cable.
3. Set the terminal software communications protocol.
4. Change the PC Card Unit’s startup mode (with the system switch).
5. Turn ON the power supply to the C200HX/HG/HE and the personal com-
puter.
6. Use the terminal software at the personal computer to start SETUP2.EXE.
Note To return the PC Card Unit to normal operation after the settings have been
made by SETUP2.EXE, change the startup mode. This procedure is explained
in 7-7-4 Returning the PC Card Unit to Normal Mode.
Terminal Software Communications Protocol
Set the personal computer’s terminal software communications protocol as fol-
lows: 9,600 bps, 8 bits, non-parity, 1 stop bit (8N), flow control XON/XOFF.
Using SETUP2.EXE
Section 7-7