Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 103 / 261

87
7-6 Setup Software Operation
7-6-1
Preset Items
Before starting Ethernet communications through the Ethernet card, use the
setup software to set up the Ethernet communications environment.
Note Before setting up the Ethernet communications environment, connect the PC
Card Unit to the personal computer and copy the setup software as described in
7-4 Personal Computer Setup.
The items set using the setup software are described on the following pages.
Menu Description
1. Enter IP address for UNIT Specify the IP address of the PC Card
Unit.
2. Enter Subnet address for UNIT Specify the subnet mask of the PC Card
Unit.
3. Enter ODI Driver Path. Specify the file name (including the
extension “.COM”) of the ODI driver
provided with the Ethernet card. Copy
the ODI driver file to the same directory
as the setup software beforehand.
4. Edit HOSTS File. Set the HOSTS file for the IP network.
To do so, you can copy the existing
HOSTS file or create a new HOSTS file.
Insert a space between the IP address
and host name. The maximum number
of lines in the HOSTS file is 127.
5. Edit Conversion Table for IP address
and FINS Node address Specify the conversion correspondence
between each pair of a FINS node
address and IP address. Specify IP
addresses in decimal notation. Note that
if 0 is added to the beginning of each
field, the address will be interpreted as
an octal number. Enter a space between
the IP address and node address.
6. Edit Routing Table for FINS. Specify the data required for
internetwork communication. The data
consists of a local network table and a
relay network table. Even if there is only
one network, specify just the local
network table. If the PC Card Unit is to
communicate with a node on another
network, the relay station must be a
CV-series PC.
7. Edit Gateway address for UNIT Enter the IP address to be used as a
gateway with other Ethernet networks.
8. Transfer Setup Data From Computer
to UNIT Transfer the data specified using the
setup software to the PC Card Unit.
9. Exit Exit the setup software to return to the
DOS prompt.
7-6-2 Starting and Exiting the Software
This section describes how to start and exit the setup software.
Note 1. Before starting the setup software, copy all files from the setup floppy disk to
the hard disk. Before copying the setup software, make sure that the copy
destination does not contain any files that have the same file names as
those in the setup software.
Preset Items
Setup Software Operation
Section 7-6