Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 241 / 261

225
Appendix J
Remote Tool Connection Procedure
This appendix explains the procedure for remote tool connection to the C200HX/HG/HE via the PC Card Unit inter-
face by peripheral bus connection to the C200HX/HG/HE and host link connection from SYSMAC Support Soft-
ware (SSS). This function can be used from the C200HW-PCS01-EV1 PC Card Unit Ethernet Set.
Outline
When the system is configured as shown in the following diagram, remote tool connection can be executed for a
C200HX/HG/HE on the Ethernet.
System Configuration Example
Ethernet
C200HW-PCS01-EV1
PC Card Unit C200HW-PCS01-EV1
PC Card Unit C200HW-PCS01-EV1
PC Card Unit
Host link or
peripheral bus
connection
Personal computer,
SYSMAC Support
Software (SSS)
•
Remote tool connection can only be executed between C200HX/HG/HE Programmable Controllers with PC
Card Units mounted. It cannot be executed for other C-series or CV-series PCs.
•
Remote tool connection cannot be executed unless the Ethernet environmental settings are completed for the
PC Card Units at both the local and remote nodes.
•
Personal computers with SYSMAC Support Software installed can be connected to C200HX/HG/HE Program-
mable Controllers by host link or by peripheral bus. If a personal computer is directly connected to a PC Card
Unit, peripheral bus connection cannot be used.
Restrictions
With remote tool connection via PCU Card Unit Ethernet, it is not possible to use SYSMAC Link-related functions
such as starting and stopping SYSMAC Link and making data link settings.