![background image](http://html1.mh-extra.com/html/omron/sysmac-c200hw-pcs01-ev1/sysmac-c200hw-pcs01-ev1_operation-manual_742247090.webp)
74
7-1
Preparations
Before setting up the Ethernet, always perform the setup procedure described
below.
Note The service conditions, slots used, and restrictions on PC cards are the same for
the PC Card Unit Ethernet Set as for the PC Card Unit. Be sure to observe the
restrictions described in Section 4 Installation and Switch Settings.
1, 2, 3...
1. Mounting the Communications Board
Mount the C200HW-COM01 or C200HW-COM04-E Communications
Board in the C200HX/HG/HE CPU. Refer to the C200HW-COM01 to 06-E
Communications Board Operation Manual for details.
2. Setting Up the C200HX/HG/HE
•
Adding CMCR
Use the SYSMAC Support Software or Programming Console to allocate a
function code to the CMCR instruction (CARD MACRO instruction).
•
Setting the System Switch
Turn ON pin no. 4 on the DIP switch to enable allocating function codes to
expansion instructions for the C200HX/HG/HE.
3. Setting Up the PC Card Unit
•
Setting the System Switch
Set the startup mode, memory card format, operating level, etc. If only a
memory card is to be used, set the operating level only. Other pins can be left
OFF.
•
Connecting the PC Card Unit to Peripherals
Install the PC Card Unit on the CPU Backplane, and mount a Bus Connec-
tion Unit and memory card.
7-2
Installing and Removing the Ethernet Card
This section describes restrictions on Ethernet cards and explains how to install/
remove an Ethernet card in/from the PC Card Unit.
7-2-1 Ethernet Cards
Applicable Ethernet Cards
The PC Card Unit uses a DOS ODI driver. Although two DOS ODI drivers are
currently in existence (SPEC3 and SPEC4), the PC Card Unit supports the
SPEC3 ODI driver only. Therefore, Ethernet cards that have only the SPEC4
ODI driver cannot be used.
Note
1. Before installing or removing an Ethernet card, always turn the PC Card Unit
OFF. An Ethernet card cannot be installed or removed while the PC Card
Unit is ON.
2. Only one Ethernet card can be used.
4-1
4-1
4-3
4-4 to 4-6
Installing and Removing the Ethernet Card
Section 7-2
Summary of Contents for SYSMAC C200HW-PCS01-EV1
