Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 114 / 261

98
7-6-10 Transferring Settings to the PC Card Unit
Transfer the data specified using the setup software to the PC Card Unit.
1, 2, 3... 1. Select “8. Transfer Setup Data From Computer to UNIT” from the main
menu.
.
.
Select Number for ITEM (1–9): 8
Connect Computer to UNIT with RS-232C Cable,
Change DIPSW to FILE Transfer mode, and Turn on UNIT.
If UNITRUN LED turns on, press Enter key.
2. After the RUN indicator on the front panel of the PC Card Unit lights, press
ENTER. The following message will be displayed during file transfer.
Transferring Setup Data...
Now transferring ROUTE.FIL...
When the transfer is finished, the screen will return to the main menu.
Note 1. Even if only part of the settings is changed, it takes 35 minutes because the
setup software transfers all files. Use the SETUP2.EXE for the second or
later settings
2. When transferring individual files, follow the following procedures. It is rec-
ommended that SETUP2.EXE be used because the PC Card Unit may not
operate if the settings are incorrect.
Enter the following command from the directory in which SETUP.EXE was
installed:
>FTRANS filename /S /Z /F /COM2
•
Transfer the modified files and SETUP.FIL.
•
Change the HOSTS file name to HOSTS.
•
If the IP address of the local node has been changed, transfer ALIAS.
7-6-11 Exiting
When transfer has been completed, exit the setup software. Wait for at least 5
seconds after exiting the setup software and then restart the PC Card Unit.
7-6-12 Confirmation
If the settings are correct, the RUN indicator on the front panel of the PC Card
Unit will light after re-starting the Unit.
Execute the SEND and RECV instructions and the FINS internode echo test to
check whether address settings and other settings are all correct. Refer to Sec-
tion 8 Using SEND(90) and RECV(98) for details on SEND and RECV.
Note Transferring Settings via Memory Card
When Ethernet network settings are to be transferred to more than one PC Card
Unit, use of a memory card can reduce the transfer time required.
Setup Software Operation
Section 7-6