Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 111 / 261

95
•
Selecting “Display Previous Item (11)” scrolls up the screen to display the pre-
vious 10 lines.
•
Selecting “Display Next Item (12)” scrolls down the screen to display the next
10 lines.
7. After editing the Conversion Table for IP Address and FINS Node Address,
select “End (13).”
Enter Number of Line To Change (0–9), Add Line (10), Delete Line (0–9),
Display Previous Item (11), Display Next Item (12), End (13): 13
The screen will return to the main menu.
7-6-8 FINS Routing Tables
Editing the routing tables for FINS is described next. Set the local network and
relay network.
Note Always specify both the local network and relay network during the editing pro-
cedure. Even if only one of the networks needs to be modified, always perform
the setting procedures for both of them.
1, 2, 3... 1. Select “6. Edit a Routing Table for FINS.” from the main menu.
.
.
Select Number for ITEM (1–9): 6
Current Routing Table for FINS: route.fil
New Routing Table for FINS:
2. If a new routing table file is to be created, press ENTER. If a routing table file
has already been created for another Unit, enter the file name.
New Routing Table for FINS:
: route.fil May I setup current data? (Y/N)
3. Check that the file name is correct. Then, enter Y and press ENTER. The file
edit screen is displayed as shown below. To cancel the setting, enter N and
press ENTER to return to the main menu.
1. Set My Network address
2. Set Relay Network address
3. Exit
Select Number of Item (1–3):
Setup Software Operation
Section 7-6