Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 118 / 261

102
Exiting SETUP2.EXE Select “9. Exit” from the main menu. SETUP2.EXE will be exited, and the termi-
nal software prompt will be displayed.
Enter ODI Driver Path
1, 2, 3... 1. Select “3. Enter ODI Driver Path.” from the main menu.
.
.
Select Number for ITEM (1–9): 3
Current ODI Driver : OC–NET–N.COM
New ODI
Driver:
2. Enter an ODI driver name (including the extension “.COM”). The drive and
the directory cannot be specified. Only the filename must be specified.
New ODI Driver : ce2odi.com
: ce2odi.com May I setup current data? (Y/N)
3. Make sure that the ODI driver name is correct. Then, enter “Y” and press
ENTER. The registered driver will be deleted from the PC Card Unit’s drive
F. At that time the PC Card Unit will go into one-file waiting-to-receive status
by Z MODEM. Normally the terminal software will automatically start the Z
MODEM, and the specified screen for the file to be transferred will be dis-
played.
4. Specify the new driver that was set in step 2 and transfer that driver. This
operation differs depending on the terminal software that is used, so refer to
the appropriate terminal software manual. When the transfer is complete,
the main menu will be restored.
Uninstall By executing “8. Uninstall,” the Ethernet communications environment settings
that have been set for the PC Card Unit can be deleted.
Note When “8. Uninstall” is executed, the PC Card Unit’s Ethernet settings are all
deleted. This returns the PC Card Unit to its original status, so the setup must be
performed again in order to use the Ethernet function.
Uninstall is a function provided with the C200HW-PCS01-EV1. It cannot be used
for a Unit with the C200HW-PCS01-E installed.
1, 2, 3... 1. Select “8. Uninstall” from the main menu. The following screen will be dis-
played.
Uninstall will delete all Ethernet settings.
Are you sure that you want to uninstall Ethernet settings? (Y, N)
2. Enter “Y” and press ENTER. The following screen will then be displayed. (If
“N” is entered and ENTER is pressed, the main menu will be restored and
the operation will not be performed.
All Ethernet settings have been deleted. When you setup Ethernet settings,
do all over again. (Y)
3. Enter “Y” and press ENTER. SETUP2.EXE will be exited.
Using SETUP2.EXE
Section 7-7