Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 115 / 261

99
Follow the procedure below.
1, 2, 3... 1. After the Ethernet network is set up using the setup software, exit the setup
software without transferring the settings to a PC Card Unit.
2. Format an SRAM or ATA card with your computer.
3. Copy the files shown below to the route directory of the memory card for-
matted in Step 2. Copy these files from the directory from which SETUP.EXE
was run (or from the floppy disk).
Files to be Copied
ALIAS
BASE.BAT
BASE_E.EXE
CDL.EXE
CDRVODI.EXE
CLSINET.EXE
CML.COM
CONFIG.SYS
CTCPIP.EXE
DNSCLR.EXE
HOSTS (Renamed file of the specified HOST settings file.
Always use file name HOSTS.)
ID
INETBIOS.EXE
INETCOM.COM
IP_FINS.FIL (or the specified IP-FINS conversion
settings file)
LINKBUS.EXE
NET.CFG
NOSBASE.EXE
NOWODI
OC-NET-N.COM (or the ODI driver of your Ethernet card)
READHOST.EXE
ROUTE.FIL (or the specified routing table settings file)
SETUP.FIL
SETUP2.EXE
TCPIP.CFG
TEMU.INF
INST.BAT
4. Insert the memory card (to which these files have been copied) into slot 1 in
a PC Card Unit.
5. Turn ON only pin 3 of the system switch on the front panel of the PC Card
Unit. Also, change the pin 1 setting depending on your operating level.
6. Turn on the PC Card Unit.
7. Transfer of the settings is complete when the RUN indicator on the front
panel of the PC Card Unit lights. Remove the memory card, return the sys-
tem switch settings to the original state, and turn the power OFF, then ON.
8. If the memory card is used to transfer data to another PC Card Unit, repeat
the above procedure.
If the settings are to be changed, do not modify the files directly. Always start
the setup software, then make the necessary modifications.
Setup Software Operation
Section 7-6