Omron SYSMAC C200HW-PCS01-EV1, Operation Manual

Page: 198 / 261

182
11-2-10 FILE DELETE
Deletes files stored in a file device connected to the PC Card Unit.
Command Block
22 05
Disk no. Command
code
No. of
files
File name File name
12 bytes 12 bytes
Parameters Disk no. (command): Specify the file device (memory card) as follows:
G drive (slot 1): $0006 H drive (slot 2): $0007
No. of files (command): The number of files to be deleted
File name (command): The names of the files to be deleted (in capital letters).
Set as: File name of up to eight l 3-letter extension. One-byte
alphanumeric code is used. When there are not enough letters to fill all 12 bytes,
fill the remaining bytes with spaces ($20).
Response Block
Response
code
Command
code
No. of
files
No. of files (response): The number of files that have been deleted.
Note 1. The specified files will be deleted in sequence. If nonexisting file names
have been specified, the PC Card Unit will ignore them and the operation will
continue.
2. If the specified number of files and the number of file names do not coincide
no files will be deleted.
Response code
Refer to Appendix E FINS Response Codes from the PC Card Unit.
11-2-11 FILE COPY
Copies a file onto the memory card of the PC Card Unit.
Note Do not create any files on the memory card that begin with “TMP...”. The system
uses this prefix.
Command Block
Command
code
Disk no. (Destination)
12 bytes 12 bytes
File name (Destination)
File name (Source)
Disk no. (Source)
Parameters Disk no. (command): Set the file device (memory cards) as follows:
G drive: $0006
H drive: $0007
File name (command): The file to be copied and a new name for the copied file.
Set as: File name of up to eight l 3-letter extension. One-byte
Shift JIS alphanumeric code is used. When there are not enough letters to fill all
12 bytes, fill the remaining bytes with spaces ($20).
PC Card Unit Commands and Responses
Section 11-2