![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538084.webp)
63
Connecting to the RS-232C Port at the Host
Section 2-6
Either set PLC Setup directly from a Programming Device (Programming Con-
sole), or transmit the PLC Setup made at a Programming Device (CX-Pro-
grammer) to the CPU Unit. For details on PLC Setup ,refer to the
SYSMAC
CS Series Operation Manual
(W339-E1-
@
) or
SYSMAC CJ Series Operation
Manual
(W393-E1-
@
).
Setting the Front Switches
Set pins 4 and 5 of the CPU Unit DIP switch according to the port that the
NT20 is connected to.
Connecting to CS-series Serial Communications Board
Serial Communications Board equipped with a RS-232C port for CS-series
CPU Units: CS1W-SCB41/21
Peripheral port
RS-232C port
DIP switches (inside the battery storage)
SYSMAC CS1G
PROGRAMMABLE CONTROLLER
CPU42
OPEN
OPEN
PERIPHERAL
PORT
BUSY
RUN
ERR/ALM
INH
PRPHL/COMM
MCPWR
CS1G/H, CS1G/H-H
CJ1G
DIP switches (inside the battery storage)
Peripheral port
RS-232C port
This is used mainly for
connection to the
Programming Device.
(This also supports the
RS-232C Unit connection.)
This is used mainly for
connection to the RS-
232C Unit.
(This also supports a
CX-Programmer
connection.)
This is used mainly for
connection to the
Programming Device.
(This also supports the
RS-232C Unit connection.)
This is used mainly for connection to the RS-232C
Unit. (This also supports a CX-Programmer
connection.)
•
Set pin 4 to ON (establishing communications in
accordance with PLC Setup) when connecting
the NT20 to the peripheral port.
•
Set pin 5 to OFF (establishing communications
in accordance with PLC Setup) when
connecting the NT20 to the RS-232C port.
•
Set pin 4 to ON (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the peripheral port.
•
Set pin 5 to OFF (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the RS-232C port.
Summary of Contents for NT20
