43
Using a Memory Unit
Section 2-5
Verify error
An error occurred during veri-
fication processing at the flash
memory of the NT20 or the
Memory Unit.
Turn the NT20 power OFF,
then back ON. If the error
recurs, the flash memory at
the write destination may be
faulty. In this case, replace the
Unit.
Transmitting data
error (The automatic
transmission only)
An attempt is made to trans-
mit data other than a system
program or the system pro-
gram of a different PT model
into the NT20 as the system
program.An attempt is made
to write a system program into
the NT20 as screen data.
Perform either of the following
procedures.
• Turn the NT20 power OFF,
correct the DIP switch set-
tings of the Memory Unit,
and then turn the power
back ON.
• Turn the NT20 power OFF,
set the DIP switch settings to
the manual transmission,
and then check the data
inside the Memory Unit.
Error
Probable Cause
Remedial Action
Summary of Contents for NT20
