Omron NT20, User Manual

Page: 151 / 311

130
Transferring the Resource Data Section 3-11
When the NT20 starts reception, the screen shown below will be dis-
played.
6. When transfer of the system program has completed, the NT20 will be dis-
plays the screen shown below.
Points to Observe during
Transfer of the Resource
Data If any of the following events or a system error occurs during transfer of the
resource data, the program will not be installed in the NT20 correctly.
• The power to the NT20 is turned OFF or the NT20 is reset during transfer.
• The power to the personal computer that is running the System Transfer
Tool is turned OFF or the personal computer is reset during transfer.
• The cable connecting the personal computer running the System Transfer
Tool and the NT20 becomes disconnected or sustains a wire breakage
during transfer.
• Transfer is terminated by pressing the ABORT Button on the NT20.
• Transfer is terminated by pressing the ESC key of the personal computer
running the System Transfer Tool.
In the event of any of the above, a resource error will occur.
To prevent this, turn ON DIP switch SW2-5 to erase the resource data after
the problem has occurred. For details on erasing the resource data with the
DIP switch, refer to
Method for Erasing the Resource Data .
Method for Erasing the
Resource Data In order to erase the resource data, the resource data area must be cleared. If
resource data already exists, it must be erased before the new data can be
transferred.
Use the following procedure to erase the resource data.
Operation 1. Set DIP SW2-5 to the ON position and turn ON the power or reset. The fol-
lowing screen will be displayed.
ABORT
Downloading
0KB
[ Download Resource ]
Downloading is completed.
Turn OFF the DIP Switch 2-5
And push the Reset Switch.
Then return to RUN mode.