![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538148.webp)
127
Transferring the System Program
Section 3-10
6.
When transfer of the system program has been completed, the NT20 will
display the screen shown below.
7.
Press the
Run system
Button when using the system transfer tool to re-
turn to run mode.
Points to Observe during
Transfer of the System
Program
If any of the following events or a system error occurs during transfer of the
system program, the program will not be installed in the NT20 correctly.
• The power to the NT20 is turned OFF, or the NT20 is reset during transfer.
• The power to the personal computer that is running the System Transfer
Tool is turned OFF, or the personal computer is reset, during transfer.
• The cable connecting the personal computer running the System Transfer
Tool and the NT20 becomes disconnected or sustains a wire breakage
during transfer.
• Transfer is terminated by pressing the
Abort
Button on the NT20.
• Transfer is terminated by pressing the ESC key of the personal computer
running the System Transfer Tool.
In the event of any of the above, there is a possibility that the NT20 will not
operate or that unpredictable malfunctions will occur.
To prevent this, turn ON DIP switch SW2-6 to erase the system program after
the problem has occurred. For details on erasing the system program with the
DIP switch, refer to
Method for Erasing the System Program
(page 127).
Method for Erasing the
System Program
In order to erase the system program, the system program area must be
cleared.
If a system program already exists, it must be erased before the new one can
be transferred.
Use the following procedure to erase the system program.
Operation
1.
Set DIP SW2-6 to the ON position and turn ON the power or reset. The fol-
lowing screen will be displayed.
Abort
-Download System Program-
[System Installer V1.00]
Downloading…
Run System
-Download System Program-
Downloading is completed
[System Installer V1.00]
Summary of Contents for NT20
