![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538125.webp)
104
Registering the Screen Data
Section 3-6
6.
When the screen data transmission is completed, the Support Tool will dis-
play the following screen.
7.
Press any key on the Support Tool to return to the File Selection screen.
8.
Pressing the ABORT touch switch in the Transmit Mode screen of the
NT20 will exit the Transmit Mode and enter the RUN Mode.
Note
Press the “Abort” touch switch on the NT20 when the screen data transmis-
sion is completed. Unless this touch switch is pressed, the screen data will not
be correctly registered. If the “Abort” touch switch is pressed during transmis-
sion, the screen data will not be correctly registered.
If screen data cannot be transmitted from the Support Tool, confirm normal
communications between the NT20 and the Support Tool (Personal com-
puter). Use the tool communications check function in the Maintenance Mode
of the NT20 to check communications with the Support Tool. Refer to
Check-
ing the Communications with the Support Tool
on page 116.
Precautions to Be Observed during Screen Data Transmission
When any of the following or a system error occurs during the screen data
transmission, the transmitted screen data will not be registered correctly to
the NT20. If an error message is displayed in the System Menu and the RUN
Mode cannot be selected, the screen data memory needs to be initialized.
• The power to the NT20 is interrupted or reset.
• The power to the computer on which the Support Tool is running is inter-
rupted or reset.
• The cable connecting the NT20 to the computer on which the Support
Tool is running is interrupted or reset.
• The “Abort” touch switch on the NT20 screen is pressed to end the trans-
mission.
• The ESC key on the Support Tool is pressed to end the transmission.
When the power to the NT20 is turned ON or reset, the screen data is
checked. However, if any of the above occurs during the screen data trans-
mission, the screen may disappear and other unexpected problems may
occur.
In the case of such problems, set DIP SW2-1 to ON to initialize the memory.
For the memory initialization by using the DIP switch, refer to the
3-4-2 Initial-
ization by Using the DIP Switch (Forced Initialization)
on page 90.
ABORT
[ TRANSMIT MODE ]
Tool
→
PT
Screen Data
0 KB
Tool Mode NT20S
Summary of Contents for NT20
