![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538087.webp)
66
Connecting to the RS-232C Port at the Host
Section 2-6
Connecting CS/CJ-series CPU Units
CS-series CPU Unit model: CS1G/H-CPU
@@
-EV1, CS1G/H-CPU
@@
H
CJ-series CPU Unit model: CJ1G-CPU
@@
PLC Setup
When connecting to a CS/CJ-series CPU Unit, set the following communica-
tions conditions for the PLC Setup, according to the communications port to
be used.
When using the built-in RS-232C port of a CS1G/H, CS1G/H-H, or CJ1G
When using the peripheral port of a CS1G/H, CS1G/H-H, or CJ1G
When connecting PTs with model numbers 0, 2, 3, 4, and 5 to the built-in RS-
232C port, for example, set CIO 160 to 8200 Hex, CIO 161 to 000A Hex, and
CIO166 to 0005 Hex.
Either set PLC Setup directly from a Programming Device (Programming Con-
sole), or transmit the PLC Setup made at a Programming Device (CX-Pro-
grammer) to the CPU Unit.
For details on PLC Setup, refer to the
SYSMAC CS Series Operation Manual
(W339-E1-
@
) or
SYSMAC CJ Series Operation Manual
(W393-E1-
@
).
Note
When using the CX-Programmer to set the high-speed 1:N NT Link, set the
communications baud rate to 115,200 bps.
Setting the Front Switches
Set pins 4 and 5 of the CPU Unit DIP switch according to the port that the
NT20 is connected to.
Word
Value
Settings
160
8200
1:N NT Link mode
161
000A
Communications baud rate (high-speed)
166
000
@
@
= The largest model number of the con-
nected PT (0 - 7)
Word
Value
Settings
144
8200
1:N NT Link mode
145
000A
Communications baud rate (high-speed)
150
000
@
@
= The largest model number of the con-
nected PT (0 - 7)
Summary of Contents for NT20
