![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538076.webp)
55
Connecting to the RS-232C Port at the Host
Section 2-6
Setting the Front Switches
Set pins 4 and 5 of the CPU Unit DIP switch according to the port that the
NT20 is connected to.
Connecting to CS-series Serial Communications Board
Serial Communications Board equipped with a RS-232C port for CS-series
CPU Units: CS1W-SCB41/21
Allocation DM Area Settings for CPU Unit
Settings are written from the Programming Device (a Programming Console
or CX-Programmer) directly into the allocated DM Area (PLC Setup) of the
CPU Unit. After the settings are written, they become effective by turning the
power ON, restarting the Unit, restarting the communications port, or execu-
tion of the STUP instruction.
DIP switches (inside the battery storage)
Peripheral port
RS-232C port
SYSMAC CS1G
PROGRAMMABLE CONTROLLER
CPU42
OPEN
OPEN
PERIPHERAL
PORT
BUSY
RUN
ERR/ALM
INH
PRPHL/COMM
MCPWR
CS1G/H, CS1G/H-H
CJ1G
DIP switches (inside the battery storage)
Peripheral port
RS-232 port
This is used mainly for
connection to the
Programming Device.
(This also supports the
RS-232C Unit connection.)
This is used mainly for
connection to the RS-
232C Unit. (This also
supports a CX-
Programmer
connection.)
This is used mainly for connection
to the Programming Device.
(This also supports the RS-232C
Unit connection.)
•
Set pin 4 to ON (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the peripheral port.
•
Set pin 5 to OFF (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the RS-232C port.
•
Set pin 4 to ON (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the peripheral port.
•
Set pin 5 to OFF (establishing communications in
accordance with PLC Setup) when connecting the
NT20 to the RS-232C port.
This is used mainly for connection to the RS-232C
Unit. (This also supports a CX-Programmer
connection.)
Summary of Contents for NT20
