59
Connecting to the RS-232C Port at the Host
Section 2-6
Setting the Switches of a CPM2A
When using a CPM2A, the switches on the front panel must be set as shown
below in order to make the PLC Setup settings effective.
Setting the Switches of a CPM2C
When using a CPM2C, the switches on the front panel must be set as shown
below in order to make the PLC Setup settings effective.
Setting the Switches on an RS-232C Adapter
When using a CPM1-CIF01 RS-232C Adapter, set the mode switch as shown
in the following diagram.
C200HX/HG/HE(-Z)E
CQM1
CQM1H
RS-232C port communications condition setting
Set pin 5 to OFF to make the settings made in
PLC Setup effective.
Set the Communications
switch to OFF (down
position).
•
Connecting PT to peripheral port
•
Connecting PT to built-in RS-232C port
SW1: OFF
SW2: ON
•
Connecting PT to built-in RS-232C port
(A Programming Console is connected to the peripheral port.)
SW1: OFF
SW2: OFF
The settings for SW1 and SW2 depend upon the usage of
the peripheral port and RS-232C port.
(A device that requires non-standard communications
settings is connected to the peripheral port.)
CPM1-
CIF01
Set the mode setting switch to NT (lower position).
Summary of Contents for NT20
