![background image](http://html.mh-extra.com/html/omron/nt20/nt20_user-manual_744538133.webp)
112
Various System Settings
Section 3-8
Set the Support Tool mode by the menu operation from the system menu
shown below.
To quit after setting the selected item, press the WRT & EXIT touch switch. To
quit without setting, press the Quit touch switch. The NT20 will enter the RUN
mode.
• When “NT20M” or “NT20S” is set, the NT20M/NT20S compatible mode is
established and the terminal can be used as an NT20M/NT20S.
• When “NT20” is set, the terminal can be used as an NT20.
Note
Before uploading screen data from the NT20 to the Support Tool,
confirm that the model information for the screen data in the NT20
and the Tool's transfer mode match. If they do not match, the up-
load may fail or data may change, preventing correct operation.
3-8-6
Lamp Bit Control (NT20-ST128)
When using the NT20-ST128 (using the RS-232C interface for communica-
tions with the host), you can select whether lamp status is controlled by bit
designation or not.
The factory setting for this function is “Enable” (lamps numbered 0 to 31 con-
trolled by bits).
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
Select “Maintenance Mode”.
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
DIP-SW Status
Init. Memory
Memory Switch
Select “Memory Switch”.
Comm. Type
Key Sound
Buzzer Sound
Host Link
OFF
Bk light Off
Tool Mode
OFF
None
NT20S
(1/2)
Quit
[ MEMORY SW MENU ]
Page
WRT
&
EXIT
Each time the “Tool Mode”
touch switch is pressed, the
setting option alternates
between “NT20”, “NT20S”,
and “NT20M”.
(The figure to the left shows
the NT20-ST121
@
-E
screen.)
Summary of Contents for NT20
