![background image](http://html1.mh-extra.com/html/omron/fz4-series/fz4-series_user-manual_1633222589.webp)
8
Appendixes
FZ4 User's Manual
Measurement Mechanism
587
Noise Width
Set the width for judging noise.
●
When no color is specified
If another edge is detected within the width range starting from the point where an edge was first
detected, the newly detected point is considered noise.
●
When a color is specified
If the color difference distributions again falls below the edge level within the width range starting
from the point where an edge was first detected, the newly detected point is considered noise.
When points are mistakenly detected as edges due to noise, increase the color difference value.
Defect Detection Measurement
Color changes within the measurement region are used to find defects such as scratches,
contamination, and chipping.
After measurement region is drawn, a rectangle (defect detection region) is automatically formed in this
region.While moving the defect detection region around, calculate average density for each area to
determine the difference between the original area and the surrounding area. This difference is called
the defect level. Calculate the defect level for all defect detection areas. If the maximum value exceeds
the judgement value, it is judged that there are defects in the measurement region.
Increasing "Defect size" allows for shortening of processing time, but this will reduce measurement
accuracy.
Acesst 1.0 6251194
Summary of Contents for FZ4 Series
