![background image](http://html1.mh-extra.com/html/skoda/1k0-051-437/1k0-051-437_assembly-instructions_1289039001.webp)
Distribution and Copyright by Volkswagen Zubehör GmbH 2008
1
Scope of delivery:
Special tools, test and measuring equipment, and ancillaries required:
◆
Torx Allen keys (set)
◆
Dismantling key 3409
◆
Wiring harness repair set -VAS 1978-
◆
Vehicle diagnosis, measurement and information system, e. g. -VAS 5051A-
Procedure:
Note
◆
A competent workshop should install the original hands free phone kit. Special tools and the
accompanying literature specific to the car are required for fitting it. Incorrect fitting may lead to damage
to the car or the hands free phone kit.
◆
The retrofitting can be carried out in vehicles fitted with a factory radio/radio navigation system.
◆
After completing the fitting work, the car must be coded for operation with the mobile telephone using
a car diagnostics, measuring and information system.
◆
Secure the wires so that they cannot come into contact with any rotating or other moving parts and so
that they cannot chafe on any sharp metal or plastic edges.
◆
All rights to make technical changes reserved.
◆
1 x Interface box
◆
1 x Microphone
◆
1 x Wiring set
◆
1 x Fitting material
◆
1 x Instruction manual
◆
1 x Assembly instructions
Original hands free phone kit for retrofitting
1.1
Fitting location
The following illustration shows the possible fitting locations and
the routing of the wires from the radio/radio navigation system to
the roof console.
1 - Microphone
◆
Fitting work on the factory installed fitting location in the
roof console
2 - Wiring harness
◆
Routing from the radio plug connector to the interface box
and below the storage compartment on the passenger
side, the A-pillar trim and the roof lining to the microphone
in the roof console
3 - Interface box
◆
Possible fitting locations are, depending on the vehicle and
equipment installed, on the left next to or above the
storage compartment on the passenger side, below or
behind the radio/radio navigation system
1.2
Preparing the vehicle for fitting the component
−
Switch off the ignition and all electrical equipment.
−
Remove the radio/radio navigation system, the storage
compartment of the passenger side, the right hand A-pillar
trim, the sun visors and the roof console of the vehicle.
⇒
Vehicle repair manual
CAUTION!
●
The wiring set -2- must be routed so that the function of
the passenger airbag is not limited.
●
The fitting location of the interface box -3- must be selected
so that the function of the passenger airbag is not limited.
120
140
160
180
200
220
1
2
3
VOT-1546
1K0 051 437
Assembly Instructions