Omron FZ4 Series, User Manual, Page: 157 / 656

4
Using
Tool
FZ4 User's Manual Using Custom Command 155
11 Space Insert blank character on current position of Macro edit window.
12 BS
Delete previous character of the current position of Macro edit
window.
13 DEL Delete next character of the current position of Macro edit window.
14 Enter Insert new line on current position of Macro edit window.
6.
Tap [OK].
7.
To enable the created command, place a check in the [No] checkbox.
8.
Tap [OK], and close the communication custom command screen.
Before closing the screen, the created command is saved in the file.
Common behavior of customize IO command
Basic sequence
Normally, each of IO commands are processed in the sequence as below :
1.Check input command and parameters are valid (range or type)
2.Body of the procedure
3.Output the result or response
The way of input/output command, parameters and response depends on the type of IO modules.
For detail, please refer the pages shown below.
Reference: Normal command (p.157)
Reference: Parallel IO command (p.157)
Reference: PLC link command (p.158)
Reference: Field bus command (p.158)
Control BUSY signal
Basically the BUSY flag on Customize I/O command list window should be ON.
Important
●
Executing measurement (Measure command) with BUSY flag set to ON causes error.
If you need to combine measure command with the command which is necessary to set BUSY ON
(For example, switching scene and executing measurement), please set BUSY flag OFF and write the program
like this way:
MeasureStop ' Set BUSY ON (Forbid measurement)
ChangeScene ArgmentValue#(0) ' Execute the command which can be used with BUSY ON condition
MeasureStart ' Set BUSY OFF (Permit measurement) before measurement
Measure ' Execute measurement
Acesst 1.0 6251194