Omron FZ4 Series, User Manual, Page: 327 / 656

4
Using
Tool
FZ4 User's Manual Remotely Operating the Controller (Remote Operation) 325
How to Start
1.
From the Start button located in the lower left area of the window of the remote operation PC,
select [Start] - [All Programs] - [OMRON] - [FZ4 Simulator] and then select and launch [FZ
Remote Operation Tool].
Note that a window that can be measured must be displayed on the controller.
Important
●
Do not connect or disconnect [FZ Remote Operation Tool] when a measurement is being performed or
the system is running.
2.
In the dialog box displayed by [FZ-RemoteOperator], select or directly enter the IP address and
the "Line No" of the controller to be connected. Press [Browse] to find the IP address and the line
number of the controller that can be connected.
* The "Line No" selected here is one of the following based on the system's operation mode.
Operation mode Setting
High-speed logging mode Line No = 0
Parallel-operation high-speed mode Line No = 0
Single-line High-speed mode Line No = 0
Non-stop adjustment
Measurement
window
Line No = 0
Non-stop adjustment
window
Line No = 1
Multi-line random trigger
Line 0 side Line No = 0
Line 1 side Line No = 1
The controller cannot be connected if a line number other than above is specified.
3.
As necessary, change the size of the image to transfer for the remote operation. Select ( ) to
set.
Acesst 1.0 6251194