NTT docomo FOMA N700?, Manual

Page: 521 / 597

518
D
at
a Co
mm
u
n
icatio
n
(3) Command for permitting uplink 64kbps and all
speeds of downlink (when cid is 4).
AT+CGEQMIN=4,,64
OK
(4) Command for permitting all speeds of uplink
and only 384kbps of downlink (when cid is 5)
AT+CGEQMIN=5,,,384
OK
■ Command name: +CGEQREQ=[parameter]
・ Outline
Set the QoS (quality of service) to be requested to
network when originating a packet communication.
For setting, only the pattern shown in the command
execution example can be set, which is also set as
an initial value.
Although this command is a setting command, it will
not be recorded in non-volatile memory written by
[&W], nor reset by [&F] or [Z].
・
Format
+CGEQREQ=[<cid>]
・ Explanation of the parameters
<cid>
*
: 1 to 10
*:
<cid> is a number for managing the access point
name (APN) registered in the FOMA terminal for a
packet communication. For the FOMA terminal,
you can register from number 1 to 10.
・ Operation performed when the parameter is omitted
+CGEQREQ=: Set the default value to all <cid>.
+CGEQREQ=<cid>: Set the specified <cid> to the
default value.
・
Command execution example
Only the following pattern can be set. This is set to
each cid as an initial value.
Command for requesting a connection at a speed of
uplink 64kbps and downlink 384kbps (when cid is 3).
AT+CGEQREQ=3
OK
■
Saving modem port command setting value
The values set by AT commands are initialized every time
the power of FOMA terminal is turned on or off, except the
access point name (APN) set by AT+CGDCONT command
(P. 496), QoS setting by AT+CGEQMIN/AT+CGEQREQ
command, permit or reject setting by AT
＊
DGAPL/AT
＊
DGARL/AT ＊ DGANSM command and the setting for
specifying sending/not sending caller ID of packet
communication set by AT
＊ DGPIR command. However,
you can save the values set by commands with [&W] if you
enter
AT&W
after the setting. In this case, other set values with [&W] will
also be saved. These values can be retrieved by entering
ATZ
even after the power is turned on or off.