NTT docomo FOMA N700?, Manual

Page: 494 / 597

491
Continued on next page
D
at
a Co
mm
u
n
icatio
n
W-TCP Settings
“W-TCP Settings” is a “TCP parameter setup tool” to
optimize the transmission capability of TCP/IP when
“packet communication” is carried out on the FOMA
network. The communication settings by this software are
required to make the most of communication performance
of the FOMA terminal.
Setting up and canceling optimization
<For Windows XP>
Optimization settings by dial-up are possible for Windows
XP.
1 Start the program.
(1) If you are operating from “ FOMA PC設
定ソフト
” (FOMA PC setting software)
Click “ W-TCP 設定 ” (W-TCP settings) of “ マ
ニュアル設定
” (Manual setup) after starting
the program.
(2) If you are operating from the Task Tray
Click the “W-TCP” icon in the Task Tray located
on the lower right-hand side of the desktop to
start the program.
2
Proceed with the following.
Close all the programs open and follow the
screen instructions to reboot the PC. The
optimized system settings become valid after
the reboot.
(1) If the system settings have not been
optimized
Clicking “ 最適化を行う ” (Optimize) displays
the “ W-TCP（ダイヤルアップ）設定 ”
(W-TCP (dial-up) Settings) screen. If you select
the dial-up to be optimized and click “
実行
”
(Execute), system and dial-up settings will be
optimized.
(2) If the system settings have been
optimized
The “ W-TCP （ダイヤルアップ）設定 ”
(W-TCP (dial-up) Settings) screen appears. If
there are some changes, make changes to the
settings.
(3) To cancel optimization
Clicking “ システム設定 ” (System settings)
displays the “ W-TCP 設定 ” (W-TCP
settings) screen. Click “
最適化を解除する
”
(Cancel optimization).
Note
● Cancel “ W-TCP 最適化 ” (Optimize W-TCP).
The screen shown below appears if “ W-TCP 最適化 ”
(Optimize W-TCP) is done. Click “ はい ”(Yes) to uninstall.
W-TCP optimization will be canceled after reboot.
Left-click