NTT docomo FOMA N700?, Manual

Page: 495 / 597

492
D
at
a Co
mm
u
n
icatio
n
<For Windows 98/Windows Me/Windows 2000>
1 Start the program.
(1) If you are operating from “ FOMA PC設
定ソフト
” (FOMA PC setting software)
Click “ W-TCP 設定 ” (W-TCP Settings) of “ マ
ニュアル設定
” (Manual setup) after starting
the program.
(2) If you are operating from the Task Tray
Click the “W-TCP” icon in the Task Tray located
on the lower right-hand side of the desktop to
start the program.
2
Proceed with the following.
(1) If not optimized
Click “ 最適化を行う ” (Optimize) on the “ W-
TCP 設定
” (W-TCP Settings) screen, close
all the programs open and reboot the PC to
enable the optimized settings.
(2) If optimized
A message saying “ 現在、最適化されてい
ます。 ” (Already optimized) appears on the
“
W-TCP 設定
” (W-TCP Settings) screen.
To cancel the optimization settings if connecting
to a terminal other than a FOMA terminal, click
“
最適化を解除する ” (Cancel optimization).
Close all the programs open and reboot the PC
to enable the cancellation of the optimization.
Access Point Name (APN) Settings
Set up the connecting destination (APN) for packet
communication. You can set up to 10 destinations and by
registering them into cid (Registration Numbers) 1 through
10.
● The APN setting (the connecting destination for FOMA
packet communication) is stored in the FOMA terminal. If
you connect to another FOMA terminal, therefore the APN
must be registered again.
●
When continuously using an APN on a PC, register the
same APN setting (cid setting) number with the FOMA
terminal.
●
The default setting for APN1 is mopera.
1 After starting “FOMA PC setting
software”, click “
接続先（APN）設
定 ” (Set up Connecting destination
(APN)).
2
Click “OK” on the FOMA terminal
settings acquisition screen.
Automatically accesses the FOMA terminal
connected and reads the Connecting destination
(APN) information registered.
It does not start if no FOMA terminal is connected.
3
Set up the connecting destination
(APN).
Left-click