Instruction manual
NivuSonic Clamp on
®
NivuSonic CO - Rev. 00 as of 08.12.2010
Page 7
2.2
Use in accordance with the requirements
The measurement device type NivuSonic CO including respective sensors is in-
tended to be used for continuous flow measurement in slightly polluted to clear,
clean water or equivalent media in full pipes. Here the allowed maximum values,
as specified in chapter 2.3 must be strictly kept. All cases which vary from these
conditions and are not passed by NIVUS GmbH in writing are left at owner’s risk.
The device is exclusively intended to be used for purposes as described
above.
Modifying or using the devices for other purposes without the written consent
of the manufacturer will not be considered as use in accordance with the re-
quirements.
Damages resulting from this are left at user’s risk.
The device is designed for a lifetime of approx. 10 years. After that period an
inspection in addition with a general overhaul has to be made.
For installation and initial start-up the conformity certificates and test certifi-
cates of the respective authorities must be followed.
The transmitter and the sensors always have to be installed outside of Ex-
zones!
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
