®
Instruction manual
NivuSonic Clamp on
7
Initial start-up
7.1 General
Notes to the user
Before you connect and operate the NivuSonic CO ayou should strictly follow
the notes below!
This instruction manual contains all necessary information to program and to
operate the device, addressing qualified technical staffs that have appropriate
knowledge about measurement technology, automation technology, information
technology and waste water hydraulics.
To ensure a correct function of the NivuSonic CO this instruction manual must
be read thoroughly!
The NivuSonic CO must be wired in accordance with the wiring diagram, see
chapter 6.2.3!
B If any problems regarding installation, connection or programming should oc-
cur please contact our technical division or our service centre.
General Principles
The initial start-up is not allowed until the installation has been finished and
checked. To exclude faulty programming this instruction manual must be read
before the initial start-up. Please get familiar with the NivuSonic CO program-
ming via display and keyboard by reading the instruction manual before you be-
gin to program the device. After transmitter and sensors are connected (see
chapters 6.2.3 and 6.3.3 the parameters must be set.
In the most cases all you need is:
-
geometry of the measurement place (Type) and dimensions
-
used sensors,
positioning
and alignment
-
display units
-
span and function of analog and digital outputs
The NivuSonic CO user surface was designed in a way that even unfamiliar us-
ers are able to easily set up basic settings in graphic dialog mode which ensure
reliable device operation. For extensive programming, difficult hydraulic condi-
tions, special channel shapes, in case of absence of expert staff or if a setup
and error protocol is required, the programming should be carried out by the
manufacturer or an expert company which is authorised by the manufacturer.
Page 42
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
