Instruction manual
NivuSonic Clamp on
®
NivuSonic CO - Rev. 00 as of 08.12.2010
Page 17
Ultrasonic sensors for NivuSonic CO
The sensors are available in various constructions and vary in terms of cable
length and connection. The article no. can be found on a nameplate on the cable
end (device side) which is protected by a transparent shrunk-on hose.
NIC0
K1L
Clamp On sensor pair for connection to NivuSonic CO; range ±20 m/s
0
No ATEX approval
10
10 m cable lengths, pre-configured
15
15 m cable lengths, pre-configured
20
20 m cable lengths, pre-configured
30
30 m cable lengths, pre-configured
50
50 m cable lengths, pre-configured
K
Connection to NivuSonic CO transmitter
NIC0
K1L
0
K
Fig. 4-5
Type keys for clamp on sensors
5
Storing, Delivery and Transport
5.1
Receipt
Please check your delivery according to the delivery note for completeness and
intactness immediately after receipt. Any damage in transit must be instantly re-
ported to the carrier. An immediate, written report must be sent to NIVUS GmbH
Eppingen as well.
Please report any delivery incompleteness in writing to your representative or di-
rectly to NIVUS Eppingen within two weeks.
Mistakes cannot be rectified later!
5.2
Delivery
The standard delivery of the NivuSonic CO measurement system contains:
-
The instruction manual with the certificate of conformity. Here, all necessary
steps to correctly install and to operate the measurement system are listed.
-
a NivuSonic CO transmitter
-
min. two ultrasonic sensors, construction: clamp on
-
a mounting set with a clamping strap and turnbuckles for 2 sensors
-
readout software Type, NivuSoft for Windows
®
XP, Vista and Windows
®
7
Additional accessories such as memory card, card reader or similar depending
on order. Please check by using the delivery note.
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
