®
Instruction manual
NivuSonic Clamp on
Service code
Additional system setting options are going to be revealed as soon as a special
code has been entered. It is possible to modify e.g. transmit voltages or special
adjustments regarding the transmitter crystal drive. These settings are reserved
to used by the NIVUS initial start-up service as these modifications require
comprehensive expert knowledge and do not need to be adjusted during stan-
dard use.
Damping
This menu enables to adjust the display and analog output damping between
20 and 600 seconds. This means that a 0 to 100 % jump of the calculated vol-
ume is going to require the time set to be indicated either on the display as well
as on the output.
Stability
The period within the NivuSonic CO operates without a valid velocity signal.
The NivuSonic CO falls to the value >0< using the damping previously set as
soon as this period will be overshot without detecting a correct velocity value.
Damping, example 1:
Damping 30 seconds, jump from 0 l/s to 100 l/s (=100 %) – unit requires 30 sec-
onds to run from 0 l/s to 100 l/s.
Damping, example 2:
Damping 30 seconds, jump from 80 l/s to 100 l/s (=20 %) – unit requires 6 sec-
onds to run from 80 l/s to 100 l/s.
8.5.7 Parameter Menu "Storage mode"
Fig. 8-37
Storage mode - submenu
Before enabling this menu plug in a NIVUS compact flash card with a capacity of
16 .... 128 MB. This card is available from your NIVUS representative if required.
Use memory cards purchased from NIVUS only. Other manufacturer’s cards
may lead to irreversible loss of data or measurement failure (e.g. permanent
transmitter reset).
Please plug the card into the labelled slot (>MemoryCard<) on the unit faceplate
in a way that the side identified by the numerous small holes is plugged in. Make
sure that the card is fitting tightly.
The card can be inserted in one way only, incorrect plugging is going to be
avoided due to mechanical construction. Please do not apply any force but ro-
tate the card into the correct position.
Page 66
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
