Falcon II Outdoor series printers – Maintenance Manual
87
AP-74065, Rev. 1.0, 21/11/03
Step 6 :
Apply the screw lock to the tab portions of the transmission photosensors to be installed.
Step 7 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
¾
When installing the U/D cable assembly onto the transmission photosensor, be
careful not to confuse the connectors.
Lever up cable assembly (white): front
Lever down cable assembly (blue): rear
(2) Replacing the transmission photosensor (CR origin side)
Notes :
¾
Refer to ‘Head Lock Menu’
Step 1 :
Unlock the head.
Step 2 :
Move the carriage from the capping position to the left.
Step 3 :
Remove the transmission photosensor from the ORG sensor installation board.
1 = ORG sensor installation board
2 = Connector
3 = Transmission photosensor
Notes :
¾
The ORG sensor installation board has been adjusted at the origin in factory. Do
not loosen the fixed screws.
Step 4 :
Remove the connector from the transmission photosensor.
Step 5 :
Remove the transmission photosensor.
