Falcon II Outdoor series printers – Maintenance Manual
59
AP-74065, Rev. 1.0, 21/11/03
Step 5 :
Remove the front paper guide.
Step 6 :
Remove the dryer strip(s).
Step 7 :
Degrease the plate.
Notes :
¾
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Step 8 :
Stick the dryer strip(s) onto the plate.
Notes :
¾
Make sure that the strips connect properly.
¾
Please make sure that the sensor (blue blocks) are positioned on the flat surface of
the front paper guide.
¾
Stick it as close as possible to the assembly holes. Make sure it does not touch the
assembly holes.
Notes :
¾
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
Step 9 :
Stick onto the sensors a sensor insul. patch.
1 = sensor insul. patch
2 = assembly hole
Step 10 :
Reinstall all parts in the opposite order of the removal procedure.
